Step 4 : Select the General tab, change the Startup type to Automatic, and click on the Start button. Step 6 : Located Background Intelligent Transfer Service , right-click on it and choose Properties from the context menu.
Step 7 : Select the General tab, change the Startup type to Automatic, and click on the Start button. Step 2 : Type regedit and press Enter to open up the Registry Editor. In case the value is different then modify it and click the OK to save the changes. Skip to content Windows users reported that certain updates failed to install with the unknown error Code happen to Windows 7 and Windows 8. The detail error message as below: Some updates were not installed Error s found: Code Windows Update encountered an unknown error.
Step 6 : Click on Advanced. Method 3 : I would suggest you to refer to the steps provided in the below Microsoft Help Article and check it helps. Hope it helps. For any Windows related assistance in the future, feel free to contact us and we will be glad to help. Was this reply helpful? Yes No. Sorry this didn't help. Thanks for your feedback. Hi Trevor, Thank you for your reply with the current status of the issue.
I would suggest you to try the third method again from the previous post. I have changed the steps which is applicable to Windows 7 from Windows 8. If the issue still persist, refer to the below steps. Step 1 : I would suggest you try to update the Computer in clean boot state and check if it helps. Then click View All. Click Windows Update at the bottom. Follow the instructions on the screen and then try to update Windows again.
Remove Junk Files Sometimes junk files may pile up and create internal conflicts and overload the hard disk. Steps to remove junk files are given below: Open the command prompt and run as Administrator. Type the following command and press enter.
Steps to follow are given below: First, go to My Computer and select Properties. And select Device Manager. Check if any Driver updates are available and update them. Once the update is complete we can reboot the server. Run System File Checker Usually, running the built-in system File Checker will scan and attempt to repair corrupt files and thus fix the error. First, open a terminal. Restart the computer to allow the disk check to run, this will be a bit time-consuming.
And click the Stop button to disable Services. After that re-start Cryptographic Services. System Restore Restoring the computer is only done if all the above methods fail to fi the error.
First, go to Settings and choose Recovery. Our server has 4 network adaptors, but only one is used and the other 3 are disabled. However, the properties of the active connection only show 7 entries:. I don't really know how to proceed. This is the first time we've seen any problems with Windows Updates on this server in the 6 or 7 years since it was installed.
Can anyone offer any advice, please? I'm quite happy not to bother with Silverlight and to uninstall it but I don't know if this issue might appear again during the next round of updates. I would, therefore, like to try to resolve it. Regards, Dave Patrick However, the latest round of updates have installed without a hitch. A restart prompt appeared and I restarted last night installation was successful , after which another set of updates were detected.
I installed those and restarted again and everything is fine.
0コメント